Why Your Iberian Lynx Figure Tips Over and How to Fix It
By Mojo Fun USA | Published: 2026-11-01
Category: Tips & Care
A leaning Iberian Lynx figure usually has a simple cause. Diagnose the symptom, fix the balance, and know when to display it another way.
Quick answer
Start by placing the Iberian Lynx figure on a hard, level surface. If it still tips, check whether one paw or the base sits lower, then correct the surface or support the figure rather than bending its legs.
Why a lynx figure is more prone to tipping than a wide-bodied animal
A lynx is a slender, long-legged animal, so a figure of one has a narrow footprint compared with a bulky elephant or rhino. That makes small irregularities in the shelf or the figure's stance more noticeable. The supplied catalog notes that lynx climb trees and swim to catch prey, which is useful context for posing the figure but does not change how it balances on a flat shelf.
Before you assume the figure is defective, rule out the surface. A slightly warped shelf, a soft desk mat, or a cloth runner can all make a stable figure lean. Move the figure to a bare, hard table and watch it for a minute. If it stands there, the problem is the display spot, not the model.
When the lean comes from the figure itself
If the figure tips on a known-flat surface, look at the contact points. A figure that rests on three paws or a small base can rock if one contact point is slightly short. Do not heat, bend, or sand the legs; that can damage the paint and make the lean worse. Instead, use a thin shim under the short side or place the figure on a small display base that spreads the load.
Soft or uneven surfaces are a common culprit in displays that mix figures with fabric, moss, or resin terrain. A figure that stands perfectly on a table may tip in a diorama because the ground is not level. Keep the lynx on a flat, firm patch if you build a scene around it.
Diagnose the tip-over in four checks
- Symptom: the figure rocks or falls on a hard, flat table: Place the Iberian Lynx figure on a bare table and press gently on each corner of its stance. If it rocks, one contact point is shorter. Slide a thin card or felt shim under the high side until it sits flat. If the shim fixes it, the figure is usable; move on to choosing a stable display spot.
- Symptom: the figure stands on the table but tips on the shelf: Check the shelf with a small level or a marble. A shelf that is off-level or flexes under weight will tip a narrow figure. Move the lynx to a rigid, level surface or add a thin rigid base under it. If the shelf is the cause, fix the shelf rather than the figure.
- Symptom: the figure leans only on cloth, moss, or terrain: Fabric and loose scenic material compress unevenly. Set the figure on a firm, flat patch of the display, or place a small rigid disc under its paws so it has a stable footprint. Keep the lynx on a hard patch if you build a diorama around it.
- Stop point: the figure still tips after surface and shim checks: If the figure rocks on a flat table and a shim does not steady it, do not bend or sand the legs. Display it leaning against a rock or branch in a diorama, or contact the store about the model. Choose a supported display pose instead of forcing the figure to stand unsupported.
Product note
- Iberian Lynx: The Iberian Lynx figure is a ground mammal model, and the catalog describes lynx as animals that also climb and swim to hunt. That active pose can put more weight on one side, so check the paw contact points before assuming the shelf is at fault.
Iberian Lynx
